I did a little searching and couldn't find the answer, so ...
I bought some Incra T-Track at Woodcraft today hoping to install it in my new miter slot table to hold featherboards and stuff. When I got it home and fitted it, it sits about 1/16-1/8th inch higher than the table surface. This is obviously an issue.
Anyone know if there's an easy way to correct the miter table or incra track - or should I just take this stuff back and try something else? Anyone able to recommend track that sits flush and takes a hex-head bolt (like maybe the peachtree stuff?) Unfortunately I already cut one piece, but not the other one. I guess it's still useful in making jigs - just not for this! I might still use it to attach a router fence to my spacer table on the right by the router attachment.
I bought some Incra T-Track at Woodcraft today hoping to install it in my new miter slot table to hold featherboards and stuff. When I got it home and fitted it, it sits about 1/16-1/8th inch higher than the table surface. This is obviously an issue.
Anyone know if there's an easy way to correct the miter table or incra track - or should I just take this stuff back and try something else? Anyone able to recommend track that sits flush and takes a hex-head bolt (like maybe the peachtree stuff?) Unfortunately I already cut one piece, but not the other one. I guess it's still useful in making jigs - just not for this! I might still use it to attach a router fence to my spacer table on the right by the router attachment.
Comment