The gap between my 3100 SMT and the saw table varies by 3/32" as I move the SMT back and forth. I checked and rechecked my adjustments and measurements using a framing square and the procedures for checking the miter base and the miter base parallelism in the Operator's Manual but couldn't find anything that would cause this error.
Since the SMT measures perfectly parallel to the blade using the check procedure in the manual, is it possible that I'm getting a false indication because the edge of the saw table or the SMT is not perfectly parallel to the blade?
Since the SMT measures perfectly parallel to the blade using the check procedure in the manual, is it possible that I'm getting a false indication because the edge of the saw table or the SMT is not perfectly parallel to the blade?
Comment