Folks,
just got my Incra rail and fence package (thank you Amazon prime overnight for $3.99, lmao) with the 32 inch positioner. Now Im in the process of mating things up.
The simple solution is to drill holes about 1.5 inches from the top of the table and take off the Ryobi rails.
Unfortunately I have to do things the hard way (and I want a deeper table top and intend add that in after the rails are set). I've got some Woodpeckers angle brackets that are meant for their Wondertrack. For the front rail I am using the Ryobi rail's top track with some t-nuts from the link on this forum. Need to add a couple spacers to raise everything a little bit further, but that will work. In the back I intend to use the bottom track to accomplish the same thing.
Has anybody done this before successfully? Would love to hear about it (pitfalls and great ideas for example).
just got my Incra rail and fence package (thank you Amazon prime overnight for $3.99, lmao) with the 32 inch positioner. Now Im in the process of mating things up.
The simple solution is to drill holes about 1.5 inches from the top of the table and take off the Ryobi rails.
Unfortunately I have to do things the hard way (and I want a deeper table top and intend add that in after the rails are set). I've got some Woodpeckers angle brackets that are meant for their Wondertrack. For the front rail I am using the Ryobi rail's top track with some t-nuts from the link on this forum. Need to add a couple spacers to raise everything a little bit further, but that will work. In the back I intend to use the bottom track to accomplish the same thing.
Has anybody done this before successfully? Would love to hear about it (pitfalls and great ideas for example).
Comment