Tweet
I am interested in installing a router table on my BT3100. Specifically, I want to use the 22 x 18 Woodpeck table (see link).
I welcome advice on how to attach the table to the rails. I have built table extensions using t-bolts and knobs from Jeff's. The extensions, which are based on several articles and posts from this web site, are 22" wide.
My question is whether or not I could use aluminum angle "irons" with one leg being attached to the rails and the other supporting the router table from underneath. Since the table and router will be quite heavy, I am hoping that the table can be held in place with relatively short (3/4 inch) screws driven in from the bottom. I have seen similar set-ups on this site, but am unable to find them at this time.
Helpful suggestions and critques are welcome, as always.
Regards, Steve
I welcome advice on how to attach the table to the rails. I have built table extensions using t-bolts and knobs from Jeff's. The extensions, which are based on several articles and posts from this web site, are 22" wide.
My question is whether or not I could use aluminum angle "irons" with one leg being attached to the rails and the other supporting the router table from underneath. Since the table and router will be quite heavy, I am hoping that the table can be held in place with relatively short (3/4 inch) screws driven in from the bottom. I have seen similar set-ups on this site, but am unable to find them at this time.
Helpful suggestions and critques are welcome, as always.
Regards, Steve