Hi gang - You've guys have always proven to have a diverse knowledge base, so I thought I'd pick your brains on this one.
I have two vintage Dynaco 70 tube amps running in mono that are connected to a pair of custom tri-wired speakers. The speaker connection terminals are the old stock screw type plates that are basically intended for a single u-lug type connector, so there's not much room for the tri-wire configuration of the speaker wire....I basically just twist them all together as best I can and put a u-lug connector in the terminal. One of them has come undone, and I'm thinking it's high time I did a better job with the wire terminations, so I'm open to ideas for cramming 3 wires into a single u-lug type termincal. TIA for any ideas!
Here's what my terminals look like...I only use the common and the 8 ohm leads (one side per amp):
I have two vintage Dynaco 70 tube amps running in mono that are connected to a pair of custom tri-wired speakers. The speaker connection terminals are the old stock screw type plates that are basically intended for a single u-lug type connector, so there's not much room for the tri-wire configuration of the speaker wire....I basically just twist them all together as best I can and put a u-lug connector in the terminal. One of them has come undone, and I'm thinking it's high time I did a better job with the wire terminations, so I'm open to ideas for cramming 3 wires into a single u-lug type termincal. TIA for any ideas!
Here's what my terminals look like...I only use the common and the 8 ohm leads (one side per amp):
Comment