I've been working on a 3-drawer stand for a 10" bandsaw I received over the holidays and I finally got around to mounting the drawer fronts. The spacing left to right and between drawers came out pretty good for my first attempt, however, when you look at the drawers from the side, the top edges of the drawer fronts fit tightly against the faceframes, but the bottoms of the drawer fronts are angled away from the faceframes by about a 1/16" of an inch. The fronts are pulled up tight to the drawers and I used self-closing slides so I know there is enough room. I'm thinking that the slides are mounted at an odd angle causing the drawer fronts to angle away at the bottom--if that is it, do you think I would have a chance at aligning them by moving the slides or is that asking for bigger headaches?
Has anyone else experienced this or have any suggestions? If so, I promise to post pics of the finished project as a source of amusement and laughter.
Thank you
Has anyone else experienced this or have any suggestions? If so, I promise to post pics of the finished project as a source of amusement and laughter.
Thank you
Comment