BT3000 stuck.

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Gbotha
    Forum Newbie
    • Oct 2017
    • 20

    BT3000 stuck.

    Is this the culprit, and will this one work? Blade wont raise. Reading lots of info. Right now its just a big router table. I have the extension slides, with recessed router in the top.

  • leehljp
    Just me
    • Dec 2002
    • 8429
    • Tunica, MS
    • BT3000/3100

    #2
    More than likely. Probably 10% of the time it could be threads stripped in the raise / lower . And 90% of the time, it will be the shims in the link. You may need two shims; sometimes only one has fallen out. Never hurts to have an extra on hand.
    Hank Lee

    Experience is what you get when you don't get what you wanted!

    Comment

    • joedad
      Forum Newbie
      • Mar 2015
      • 24
      • Yardley, PA
      • Ryobi Bt3000

      #3
      I can lift the blade up and down by hand. It will not lift when I turn handle. Do you think the screw has stripped.

      Comment

      • LCHIEN
        Internet Fact Checker
        • Dec 2002
        • 20914
        • Katy, TX, USA.
        • BT3000 vintage 1999

        #4
        did you get the BT3 FAQ, using the link in my signature line below?
        Loring in Katy, TX USA
        If your only tool is a hammer, you tend to treat all problems as if they were nails.
        BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions

        Comment

        Working...