Tweet
I got this leg set many years ago, along with a Wide Table Kit, in preparation for setting up my shop after retirement. Never opened the box. I did yesterday, and there are no instructions. Everything looks to be pretty self-explanatory for the set-up, but there are LOTS of extra parts left over after what my "logical, off-the-cuff" installation would be. Does anybody have a copy of the instructions they can email (or whatever) to me so I can be sure I'm doing this right?
-
-
I might still have mine! I'll check and let you know either later tonight or tomorrow morning.
Turaj (in Toronto)
"When I read about the evils of drinking, I gave up reading!" Henny Youngman
-
Thanks, Turaj.
Slow JoeComment
-
http://www.alr6x6.com/pelligrini/BT3...it_4730305.pdf
The above PDF file link appears to be the directions/manual for the leg set. Looks right to me when I downloaded it.
Actually, I attached it to this post, you can download it directly from the post by clicking on the attachment PDF file just below.
Ryobi_Leg_Kit_4730305.pdfLast edited by LCHIEN; 09-07-2016, 01:30 AM.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
-
That's it! Exactly what I needed. My guesstimate was correct, but now I see what the extra parts are for. I appreciate your help.Comment
-
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
Comment